KEYENCE IB Series - Manual (Page 24)

2-8 IB-E
2
Inst
all
at
ion and
Connec
tion
2-2
Connecting and Mounting the Sensor Head
 Mounting
Mount the sensor head with the
enclosed screws (IB-01/IB-05/IB-10:
M3, IB-30: M4).
Tightening torque: 0.3 N·m or less
(Tightening torque for IB-01: 0.1 N·m
or less)
Mounting the Sensor Head
Point
• Always use mounting holes facing the same direction for the
sensor head transmitter and receiver. (Excluding IB-01)
• Do not tighten the screws with a torque exceeding 0.3 N·m. The
sensor head could deform, thus preventing beam axis alignment.
Important
When mounting the sensor, confirm that the transmitter and receiver
faces on which the nameplate label is attached are facing the same
direction. (Only for IB-30)