KEYENCE IB Series - Manual (Page 34)

3-2 Operations on the Main Screens
3-6
3
B
a
sic O
perat
io
ns
IB-E
This section explains functions selectable from the main screen and functions selectable after
the display changes to each setting screen.
Functions available on the main screen
Setting Operations
DIN rail mount type (IB-1000/IB-1050) Panel mount type (IB-1500/IB-1550)
% HOLD
R.V.
HI
HI
LASER
GO
LO
LO
SHIFT
ANALOG ZERO SHIFT
Auto-ADJ
ZERO SHIFT TIMING
BANK0
1
2
3
CHECK
SELECT
MODE SET
Buttons used
Main screen
Press the  or  button.
Switching display on the sub display (lower level) (page 3-4)
Any of the internal measurement value (R.V.), analog output
value, HIGH setting value, LOW setting value or shift target
value are displayed and the settings can be changed.
3-6 Setting the Tolerance Setting Value (page 3-13)
HIGH setting value and LOW setting value are set. The
judgment is made among HIGH/GO/LOW, and the value is
displayed and output.
3-7 Zero Shift Function (Shifting the Internal Measurement
Value (R.V.)) (page 3-18)
The internal measurement value (R.V.) can be shifted (offset)
to an arbitrary shift target value.
While pressing down the [MODE] button, press the  or  button.
3-8 Bank Function (Registering Multiple Tolerance Setting
Values) (page 3-20)
HIGH setting value, LOW setting value, and shift target value
can be saved at up to four banks and switched.
Press the [MODE] and [SET] buttons for approx. 2 seconds.
(Reference light registration)
or
Press the  and  buttons simultaneously. (Adjust function)
3-4 Reference Light Registration (Gain Adjustment) and
Adjust Function (page 3-10)
To ensure measurement stability, make sure to perform
“reference light registration (gain adjustment)” when using
the sensor for the first time or each time the sensor head
mounting position has been changed, etc.
Press the [MODE] and  buttons for approx. 2 seconds.
or
Press the [MODE] and  buttons for approx. 2 seconds.
3-9 Key Lock Function (page 3-23)
This function prevents unwanted button operations during
measurement.
LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
HOLD CALC CHECK