Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 91)

91
5. Configuring the Receiver Technical Reference Manual-4.0.0en
systems in the field using
Applications\Determine Coord
System (see section 11.1).
Further options are available on this
screen in Advanced mode. See
section 5.1.1 for details.
Highlight Coord Sys and press
ENTER to reveal the list of coordinate
systems currently available.
Select the coordinate system that you
wish to use.
Use NEW (F2) to define a new
coordinate system. Use EDIT (F3) to
edit a coordinate system. Use DEL
(F4) to delete the selected coordinate
system and INFO (F5) to reveal the
type of transformation used.
When NEW (F2) is pressed, the
following screen appears.
Coord Sys - Defines the name of the
new coordinate system.
Further advice on Coordinate Sys-
tems is given in Section 11.
When you have set the parameters
press CONT (F1) to return to the
CONFIGURE\Position screen.
When using EDIT (F3) the same
descriptions apply.
Press CONT (F1) to return to the
CONFIGURE\Position screen.