Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 353)

353 Appendix H Technical Reference Manual-4.0.0en
Use the RSTN (F4) key to display the
Beacon Stations available on the
Sensor.
Note that the Beacon Station list has
to be transferred to the Sensor
before.
Depending on the beacon station the
Bit Rate may vary. Select Auto will
detect the bitrate automatically. Select
User defined and enter a value
according to the Beacon station.
Press CONT (F1) to close the control
panel.
Status of the RTB Module (CSI)
To access the RTB Module status
press STATUS /Interfaces, highlight
the RTB device and press VIEW (F3).
Information about the connected RTB
Module is displayed
Signal - Strength of the incoming
signal in
µ V/m.
SN Ratio - Signal to noise ratio in dB.
Frequency - The frequency on which
the RTB module is currently operat-
ing.
Bit Rate - The bit rate on which the
TB module is currently operating.