Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 271)

271 10. Status Technical Reference Manual-4.0.0en
Battery Ext - Amount of charge
remaining in the external battery.
Bat PC-Card - Battery status of the
SRAM PC Card battery. The three
status levels are OK, Low and Error.
Note that you should change the PC-
Card Battery when it becomes Low.
Failure to do so may result in loss of
data. Ensure that any data on the
card is backed up before changing
the battery. PC Flash Cards do not
use a battery.
Bat Backup - Receiver system
backup battery. When this battery
becomes low, contact your Leica
representative to arrange
replacement.
In case of a Real-Time Rover you
may press REF (F6) to display the
Memory and Battery Status of the
Reference Station.
10.10 Sensor Status 10.11 Software Version Status
serial number are displayed.
Control Mode- Displays the device
that is used to control the sensor.
Normally this the TR500.
Additionally it indicates whether the
PPS output and the Event Input
ports are available.
The Receiver model used and its
Displays the Firmware version, the
Boot software of the sensor,
Measurment Engine software,
Measurement Engine Boot software
and the Firmware for the Keyboard /
Display (TR500) currently installed.
MORE (F6) provides information on
special software settings.