Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 260)

260 10. Status Technical Reference Manual-4.0.0en
Press DATA (F3) for information
about the data being received from
the satellites.
Sat - The number of the chosen
satellite
Phase L1 - The number of phase
cycles from the Antenna to the
satellite on L1.
Phase L2 - The number of phase
cycles from the Antenna to the
satellite on L2.
Code L1 - The pseudorange to the
satellite from L1 data.
Code L2 - The pseudorange to the
satellite from L2 data.
Press AMBIG (F4) for information
about the ambiguity resolution pro-
cess.
Each Satellite used in the real-time
computation is displayed with the
ambiguity status on each frequency.
YES indicates a fixed ambiguity, NO
that the ambiguity is not yet fixed.
Press REF (F6) for information about
the Reference Station.
The Point Id and Antenna Height
(Ant Height) of the reference point
are displayed.
Then either Marker or Antenna is
displayed, indicating from where the
coordinate is given.
Press COORD (F2) to view the
coordinates in WGS84 Geodetic and
Cartesian formats and local grid
coordinates if a Coordinate System is
being used.