Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 185)

185 7. Measuring with System 500 Technical Reference Manual-4.0.0en
To select the code:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
An asterisk next to a code indicates
that it has attributes.
Press CONT (F1) to select the code.
Further information about Coding
Systems is available in Section 8.
Auto-logged points may also be free-
coded if a corresponding coding
system has been defined. The
procedure will be the same as with
Occupy Points described above.
For further information on how to
free-code Auto-logged points refer to
chapter 7.4.7 Using the AUTO key.
7.4.5 Adding a Starting Time
It will be possible to add a starting
time for a point occupation if auto
occupy has been set to Timed in the
Occupation Settings of the
Configuration Set.
Initially, the time displayed in Start
Time is the current time with the
seconds rounded to zero.
Enter the time in Start Time in
hours:minutes:seconds.