Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 340)

340 Appendix H Technical Reference Manual-4.0.0en
Radio and Repeaters
Radio devices are normally used to
transmit or receive Real-Time data.
Additionally a Radio device may also
be used to steer and communicate
with the Sensor e.g. to download raw
data from a remote location etc.
The following radio devices are
supported with System 500:
Satelline 1AS/2AS
Satelline 2ASx
Satelline 2ASxE
Satelline 3AS/3ASd
Pacific Crest RFM96W
Pacific Crest PDL
AT-RXM500 (Akasaka Tech)
Dataradio T-96S (Australia only)
Teledesign TS4000 (USA only)
The Teledesign TS4000 requires a
specific housing to be purchased
from Leica USA.
Configuring the Radio
From CONFIGURE\ Interfaces
highlight the interface (e.g. Real-
Time) you want to use with the Radio
and press EDIT (F3).
Press DEVCE (F5) to access the
device list.
Certain localised versions of the
above radios may require extra
configuration before use with System
500. In this case, highlight the radio
model used and press NEW (F2).
Enter a name (e.g. Satelline Italy) and
enter the applicable device param-
eters.
To configure a third party radio
highlight Unknown Radio and press
NEW (F2). Enter a name (e.g. Radio-
XY) and enter the applicable device
parameters.
The port settings are the parameters
used for the communication between
the Sensor and the radio. If required,
edit them to suit the radio settings or
change the radio settings.