Leica Geosystems GPS System 500 - Technical Reference Manual User Manual

Page 142

Text mode
Original mode

142

5. Configuring the Receiver

Technical Reference Manual-4.0.0en

Working Example 2

Field Proc -

You are completing a survey where you need only one point ID that needs an incrementing number
behind the text. These points will need the point ID “Point####”. However you will also survey
some individual points that will need unique point Ids.

In CONFIG\ OCUPY Pts set up a point ID
template as shown here.
Note that the Id type is set to “Change to Indiv.”.

Within the Survey panel, the first point will
automatically show the Point Id “Point0001”. Upon
pressing STORE, the next Point Id will
automatically show “Point0002”.

Requirement -

Settings -