Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 103)

103
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Coding
If you wish to select a coding system
press ENTER and choose from
Thematical or Free coding. Complete
descriptions of the coding systems
used by System 500 are given in
Chapter 8.
Press CODES (F3) to review the
codes in the chosen codelist. You
may also edit the codelist here.
Real-Time
For Static or Rapid Static
postprocessing operations select
None and press CONT (F1). Logging
Log Static Obs - Switches logging on
or off when the Receiver is in Static
mode. The receiver has to be
stationary. This is used when
performing Static Initializations or
when occupying distinct points in a
kinematic chain.
Obs Rate - The rate at which
observations will be logged when the
receiver is stationary or when it is
moving. For Static intializations or
occupying distinct points in a
kinematic chain, the rate should be
set at between 0.1-2 seconds.