Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 25)

25
2. Set-up and Connection Technical Reference Manual-4.0.0en
Use
Static/Rapid Static operations or as Reference for Kine-
matic.
The Receiver and TR500 (if used) can be assembled to
make one unit. This clips to the tripod leg or is placed in
the transport container. One connection is made to the
Antenna. Note that the Receiver can be programmed with
the TR500 prior to use which can then be omitted from the
set up.
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. GPS Antennas are AT501 or AT502. Procedures/
setup may vary if AT503, 504 or single frequency
choke ring are used.
2.3 Equipment Setup - Post Processed Static/Rapid Static/Reference on Tripod