Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 130)

130 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Coord Sys - Defines the name of the
new coordinate system.
When you have set the parameters
press CONT (F1) to return to the
CONFIGURE\Position screen.
When using EDIT (F3) the same
descriptions apply.
Press CONT (F1) to return to the
CONFIGURE\Position screen.
Further options are available on this
screen in Advanced mode. See
section 5.4.1 for details.
Formats
You can configure the way in which
information is presented when
surveying.
Format Grid - The format of grid
coordinates if they are being used.
Format Geodetic - The format of
geodetic coordinates if they are being
used.
Quality type - For real-time rover,
select Quality. This will display a
Coordinate Quality in cm within which
the position lies. This is calculated
using the standard deviations of the
coordinate components.
Defined by - Defines the components
used to calculate the Quality.
Height - 1D Height Quality
Pos - 2D Position Quality
Pos + Hgt - 3D Position Quality
Pos + Hgt + Time - 3D Position
Quality
OCUPY Counter - Defines how the
length of time spent occupying a point
is displayed. Select from Time -
normal time or Positions - the
number of position calculations.