Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 169)

169 7. Measuring with System 500 Technical Reference Manual-4.0.0en
Usually, in post-processed kinematic
surveys the Antenna will be mounted
on a pole and therefore the height will
remain constant. When an AT501/502
Antenna is used together with a
System 500 pole, the Antenna Height
is 2.00m. This may have been
specified as the default height in the
Configuration Set.
Otherwise, measure the Antenna
height and enter it.
The only time when the Antenna
height will not remain constant is
when a Static Initialization is carried
out on a Tripod and the Antenna is
then transferred onto a pole. In this
case, measure the Antenna height on
the Tripod, add the offset (with a
height hook this is 0.36m) and enter
it. Then, after pressing STOP (F1) to
finish the initialization, the Moving
Antenna height specified in the
Configuration Set will be used for the
moving part of the Kinematic chain.
7.2.3 Adding the Antenna Height
To break the auto numbering press
Shift INDIV (F5) and enter an
individual Point Id. After this point has
been stored it will return to the
previously suggested Point Id.
If you define a Point Id Template in
the Configuration Set you have even
more flexibility to automatically define
your Point Id’s.
Further information about Point Id
Templates and two working examples
are given in Chapter 5.2.