Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 192)

192 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The fields Free Code and
Description will be displayed as
above.
Highlighting the Free Code you may
either select a code from the given
codelist or enter a new code. The
Description will be displayed for the
selected Free Code. Using the NEW-
I (F4) key you may enter up to 20
attributes (Infos) for the code.
Press STORE (F1) to record the
code.
To start the logging of Auto-Points
press the Start (F6) key.
To view or change the configuration of
the Auto-Position logging press the
POS (F5) key, which accesses the
CONFIGURE\ Position Logging
panel. For further information on how
to configure the logging of Auto-
Positions see chapter 5.4 Cofiguring
the Receiver for Real-Time Rover
Operations.
If you also wish to measure “normal”
Occupy Points whilst still recording
auto-logged points press the SURV
(F3) key to move back to the main
Survey panel.
Note that the storing of Auto-Positions
stops as soon as OCUPY (F1) is
pressed. When STOP (F1) is pressed
to stop the measurement on the
Occupy Point the system will start
again with storing Auto-Positions. As
soon as STORE (F1) is pressed the
AUTO (F3) key becomes visible
again to enter the AUTO-POS panel.
While Auto-Positions are collected
the number of Positions already
measured will be displayed.
Press STOP (F6) to terminate the
logging of Auto-Points.