Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual User Manual
Page 76
76
Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 6 Interlocking and Data Transfer between Controllers
Select a communication format for a communication module based on the
modules in its remote chassis.
To add a module to the I/O Configuration folder, follow these steps.
1. In the Studio 5000 environment, right-click the level to which you want to
add the new module and choose New Module.
The Select Module Type dialog box appears.
Table 17 - Module Communication Formats
Conditions
Use This Communication Format
The remote chassis contains only analog modules, diagnostic
digital modules, fused output modules, or communication
modules
None
The remote chassis contains only standard, digital input and
output modules (no diagnostic modules or fused output
modules)
Rack Optimization
You want to receive I/O module and chassis slot information
from a rack-optimized remote chassis owned by another
controller
Listen-Only Rack Optimization
- 1734-AENT EtherNet/IP Network Configuration User Manual 22-COMM-E EtherNet/IP Network Configuration User Manual 20-COMM-E EtherNet/IP Network Configuration User Manual 1794-AENT EtherNet/IP Network Configuration User Manual 1783-Etxx EtherNet/IP Network Configuration User Manual 1769-Lxxx EtherNet/IP Network Configuration User Manual 1756-Enxx EtherNet/IP Network Configuration User Manual