Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 26)

26 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 3 Configure an EtherNet/IP Communication Module to Operate on the Network
4. Click the Port Configuration tab.
5. For Network Configuration Type, click Static to permanently assign this
configuration to the port.
6. Type this information in the appropriate fields:
• In the IP Address field, type the IP address.
• In the Network Mask field, type the network mask address.
• In the Gateway Address field, type the gateway address.
• In the Primary Name Server field, type the name of the primary server.
• In the Secondary Name Server field, type the name of the secondary
server.
• In the Domain Name field, type the domain name.
• In the Host Name field, type the host name.
IMPORTANT If you click Dynamic, on a power cycle, the controller clears the current
IP configuration and resumes sending BOOTP requests.