Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 103)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 103
Communicate with PanelView Terminals Chapter 8
4. Configure your new module.
• In the Name field, type the name of your module.
• In the IP Address field, type the module IP address.
• In the Slot field, type the chassis slot number.
• Click Change to configure these parameters:
– Module Revision
– Electronic Keying
– Communication Format
5. Click OK.
6. In the Controller Organizer, right-click the local EtherNet/IP
communication module you just added and choose New Module.
The Select Module Type dialog box appears.
IMPORTANT The number and type of configuration parameters on the New Module
dialog box varies according to the EtherNet/IP communication module
type.