Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 69)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 69
Interlocking and Data Transfer between Controllers Chapter 6
To add a producer controller to the I/O Configuration folder, follow these steps.
1. In the Controller Organizer, right-click the remote backplane and choose
New Module.
The Select Module Type dialog box appears.
2. Click the By Category tab and choose your producer controller.
3. Click OK.
Depending on the controller type, the Select Major Revision dialog box
may appear. If the dialog box appears, choose the module’s major revision
and click OK.
The New Module dialog box appears.