Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 25)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 25
Configure an EtherNet/IP Communication Module to Operate on the Network Chapter 3
Set the Network IP Address with RSLinx Software
To use RSLinx software to set the communication module’s IP address, follow
these steps.
1. From the Communications menu, choose RSWho.
The RSWho dialog box appears.
2. Navigate to the Ethernet network.
3. Right-click the EtherNet/IP module and choose Module Configuration.
The Module Configuration dialog box appears.