Configure a promass 83 flowmeter – Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 96

96
Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
Appendix C
Promass 83 Coriolis Mass Flowmeter
Configure a Promass 83
Flowmeter
You can configure the device via the local display and menus on the instrument.
On the local display of the field instrument, use the Quick Setup menus to
configure instrument parameters.
+
+
E
+
E
n
o
s
Esc
E
+
-
XXX.XXX.XX
p
r
m
q
Yes
Yes
Yes
No
No
No
Configure another system unit ?
Current output n
Pulse/
output n
Freq.
Selection output type
Automatic configuration of display ?
Quit
Assign
Current output
Current span
Value 0/4 mA
Value 20 mA
Time constant
Time constant
Failsafe mode
Failsafe mode
Failsafe mode
Assign
Freq. output
End value freq.
Value f Low
Value f High
Output signal
Assign
Pulse output
Pulse value
Pulse width
Output signal
Operation Mode
Frequency
Pulse
Automatic parameterization of the display
Corr. Vol. flow
Pressure
Mass flow
Density
Selection system units
Temperature
Quit
Unit
Corr. Vol. flow
Unit
Mass flow
Unit
Density
Unit
Length
Unit
Totalizer
Unit
Pressure
Unit
Totalizer
Language
Pre-setting
Quick Setup
HOME-POSITION
QS
Commission
Configure another output ?
Length
Unit
Temperature
Selection pre-settings
Reference
Temperature
Reference
Pressure
Process
Pressure
Selection pipe type
Pipe type
Circular
Rectangular
Internal
Diameter
Internal
Height
Internal
Width
Failsafe value
Delivery settings
Actual settings
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual