Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 23
Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
23
Configure the HART Device in RSLogix 5000 Programming Software
Chapter 2
3. On the General tab, enter the configuration information for the module.
4. Click Change.
5. For Input Data, choose Analog and HART PV.
6. On the Configuration tab, enable HART for each channel connected to a
device.
Each channel must be enabled to pass HART data to the controller.
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual