Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 30
30
Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
Chapter 2
Configure the HART Device in RSLogix 5000 Programming Software
3. Enter the configuration information for the module and choose the
HART communication format.
4. Click OK.
5. Go online and check the controller tags to make sure the device is
connected.
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual