Chapter 4, Configure a hart input module and device, Chapter – Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 53

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
53
Chapter
4
Configure the HART Device in E+H Fieldcare
Software
FieldCare is the Endress+Hauser FDT-based, plant-asset management tool for
configuring intelligent field instruments.
Configure a HART Input
Module and Device
1. Start FieldCare and open a new project.
Topic
Page
Configure a HART Input Module and Device
IMPORTANT
To
optimize FieldCare performance, it is recommended that you
verify that the correct DTMs are loaded in the catalog.
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual