Chapter 2, Chapter – Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 21

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
21
Chapter
2
Configure the HART Device in RSLogix 5000
Programming Software
The examples in this chapter use RSLogix 5000 programming software,
version 20.
Configure a HART Input
Module in a ControlLogix
System
In RSLogix 5000 software, you must have a project open with a ControlLogix
controller already configured. Make sure the project path is set to the correct
controller.
Use RSWHO Active in RSLogix 5000 software to verify that the controller,
HART input module, and devices are active.
Topic
Page
Configure a HART Input Module in a ControlLogix System
Configure a HART Input Module in a Compact I/O System
Configure a HART Input Module in a FLEX I/O System
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual