Configure a cerabar s pressure transmitter, Pressure measuring mode, Level measuring mode – Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 123: Pressure measuring mode level measuring mode

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
123
Cerabar S Pressure Transmitter
Appendix H
Configure a Cerabar S
Pressure Transmitter
You can configure the device via the local display and menus on the instrument.
On the local display of the field instrument, use the Quick Setup menus to
configure instrument parameters.
Pressure Measuring Mode
Level Measuring Mode
1)
1)
1)
2)
1) Display via on-site display only
2) Display via FieldCare
and HART handheld terminal onl y
Gauge pressure sensors
Absolute pressure sensors
SET LR V
SET UR V
POS . ZERO ADJUST
DAMPING VALUE
POS . I NPUT VA LU E
Pressure
Level
OPERATING MENU
Measured value
GR OUP SELECTION
LANGUAGE
MEASURING MODE
QUICK SETUP
MEASURING MODE
1)
1)
1)
2)
1) Display via on-site display only
2) Display via FieldCare
and HART handheld terminal onl y
Gauge pressure sensors
Absolute pressure sensors
SET LR V
SET UR V
POS . ZERO ADJUST
DAMPING VALUE
POS . I NPUT VA LU E
Pressure
Level
OPERATING MENU
Measured value
GR OUP SELECTION
LANGUAG E
MEASURING MODE
QUICK SETUP
MEASURING MODE
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual