Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 32

32
Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
Chapter 2
Configure the HART Device in RSLogix 5000 Programming Software
2. From the list, select the HART input module and click Create.
3. Enter the configuration information for the module and click Change.
4. Enter additional configuration information and click OK.
5. From the Channel Configuration tab, choose the channel.
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual