Configure a flex i/o module – Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual User Manual
Page 50

50
Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014
Chapter 3
Configure the HART Device in FactoryTalk AssetCentre Software
Configure a FLEX I/O Module
1. From the DTM Networks tree, select the FLEX rail.
2. Click Add DTM.
3. Select the FLEX I/O module and click OK.
The tree should look similar to this.
This manual is related to the following products:
- 1734sc-IE2CH E+H Instruments via HART to PlantPAx User Manual 1769sc-IF4IH E+H Instruments via HART to PlantPAx User Manual 1794-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF16H E+H Instruments via HART to PlantPAx User Manual 1756-IF8IH E+H Instruments via HART to PlantPAx User Manual 1756-IF8H E+H Instruments via HART to PlantPAx User Manual