Rockwell Automation 8510 AC Spindle Drive System User Manual - Manual (Page 77)

8 Chapter
8-73
Wiring
Chapter Objectives Chapter 8 provides the information needed to properly wire the 8510 AC
Drive System. Included in the chapter are general wiring recommendations
and detailed wiring procedures for power and signal wiring.
General Wiring Information Since most start-up difficulties are the result of incorrect wiring, every
precaution must be taken to assure that the wiring is done as instructed. All
items must be read and thoroughly understood before the actual
wiring begins.
ATTENTION: The following information is a general guide
for proper installation. The National Electrical Code and any
governing regional or local codes will overrule this information.
The Allen-Bradley Company cannot assume responsibility for
the compliance or the noncompliance to any code, national,
local or otherwise for the proper installation of this system or
associated equipment. A hazard of personal injury and/or
equipment damage exists if codes are ignored during
installation.
!
The information supplied in this manual on wire sizes, practices, layouts,
system configurations and grounding/shielding techniques for the 8510 AC
Drive System are presented as guidelines. Due to the diversity of
applications and systems, no single method of wiring is completely
applicable.
Important: This information represents common system wiring
configurations, size and practices that have proven satisfactory in a
majority of applications. The National Electrical Code, local electrical
codes, special operating temperatures, duty cycles or system configurations
will take precedence over the values and methods listed.
Important: For proper interconnection, it is recommended that
Allen-Bradley Termination Panels, Cable Assemblies and/or connectors be
used.