Rockwell Automation 8510 AC Spindle Drive System User Manual - Manual (Page 12)

Introduction
Chapter 1
1-8
System Accessories Various accessories are available for the 8510 to facilitate system
installation or to support the drive system.
- Mating Connector Kits – All signal interconnections to the 8510
utilize Honda multi-pin connectors. Mating connector kits are available
for all the Honda connectors. A mating connector kit is also available
for the AMP connector used for feedback from the motor.
- I/O Termination Panels and Cables – As an alternative to terminating
all signal wiring to the Honda connectors, termination panels with
cables are available to fan out the connections to conventional barrel
type terminal blocks. Cables in various lengths with a Honda connector
on one end are also available for termination directly to the machine
control panels.
- High Resolution Spindle Position Feedback – The high resolution
magnetic feedback, consisting of a precision ring gear and a pickup unit,
can be used for high accuracy spindle orient. This system can provide
resolutions of 225,000 to 500,000 parts per revolution with an absolute
accuracy down to 0.015 degrees.
- Mounting Adapters – For installations where it is difficult to extend
the 8510 heat sinks through the rear of the enclosure, a special mounting
adapter can be provided to allow the drive to be mounted within the
enclosure. A version to allow ducting the cooling air to the side or top of
the enclosure is also available.
- AC Line Fuse and Fuse Block Kit – Incoming AC line fuses or circuit
breakers are not included in the basic 8510. A kit that includes the
necessary fuse blocks and fuses is available.
- Transformers – Both autotransformers and isolation transformers are
available to match the main AC line voltage to the 200/230V AC drive
input requirement.