Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 81)

Select Command and Status Bits
to Sequence Machine Operation
Chapter 6
6-10
Table 6.G
(continued)
Command and Configuration Bits
Operation: Function Enabled
(when = 1):
ProĆSet
Address:
QDC Block
Addr.:
Logical Bridge set output @ end of 1st clamp close profile
(0 = start 2nd clamp close profile)
B37/296 CPC03ĆB08
set output @ end of 2nd clamp close profile
(0 = start 3rd clamp close profile)
B37/297 CPC03ĆB09
set output @ end of 3rd clamp close profile
(0 = start clamp LP close profile)
B37/298 CPC03ĆB10
set output @ end of hold profile
(0 = start preĆdecompress movement @ end of hold)
B38/296 HPC03ĆB08
set output @ end of preĆdecompress movement
(0 = start plastication profile @ end of preĆdecompress)
B38/297 HPC03ĆB09
set output at end of plastication profile
(0 = start postĆdecompression at end of plastication)
B38/488 PPC03ĆB08
set output @ end of 1st clamp open profile
(0 = start 2nd clamp open profile)
B37/616 OPC03ĆB08
set output @ end of 2nd clamp open profile
(0 = start 3rd clamp open profile)
B37/617 OPC03ĆB09
set output @ end of 3rd clamp open profile
(0 = start clamp open slow profile)
B37/618 OPC03ĆB10
Configured
Protection from
ClampĆzone
Overrun
If a clamp close profile overruns the
mold protection zone:
0 = start LPĆclose profile
1 = stop and zero outputs
B37/299 CPC03ĆB11
If a clamp open profile overruns the
clamp open slow zone
0 = start open slow profile
1 = stop and zero outputs
B37/619 OPC03ĆB11