Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 113)

Load Initial Configuration Values
Chapter 7
7-32
Table 7.A
SetĆoutput Values for Unselected Valves
If the unselected
valve controls:
and the unselected
valve type is:
and during profile,
valve action is:
and during profile,
you require:
Then Enter:
Pressure UniĆdirectional Direct acting Maximum Pressure 9999
Pressure UniĆdirectional Direct acting Medium Pressure 7500 to
5000
Pressure UniĆdirectional Direct acting Low Pressure 5000 to
2500
Pressure UniĆdirectional Direct acting Minimum Pressure 0
Pressure UniĆdirectional Reverse acting Maximum Pressure 0
Pressure UniĆdirectional Reverse acting Medium Pressure 2500 to
5000
Pressure UniĆdirectional Reverse acting Low Pressure 5000 to
7500
Pressure UniĆdirectional Reverse acting Minimum Pressure 9999
Flow UniĆdirectional Direct acting Maximum Flow 9999
Flow UniĆdirectional Direct acting Medium Flow 7500 to
5000
Flow UniĆdirectional Direct acting Low Flow 5000 to
2500
Flow UniĆdirectional Direct acting Minimum Flow 0
Flow UniĆdirectional Reverse acting Maximum Flow 0
Flow UniĆdirectional Reverse acting Medium Flow 2500 to
5000
Flow UniĆdirectional Reverse acting Low Flow 5000 to
7500
Flow UniĆdirectional Reverse acting Minimum Flow 9999
Flow BiĆdirectional Direct acting Maximum Flow 9999
Flow BiĆdirectional Direct acting Medium Flow 8750 to
7500
Flow BiĆdirectional Direct acting Low Flow 7500 to
6250
Flow BiĆdirectional Direct acting Minimum Flow 5000
Flow BiĆdirectional Reverse acting Maximum Flow 0
Flow BiĆdirectional Reverse acting Medium Flow 1250 to
2500
Flow BiĆdirectional Reverse acting Low Flow 2500 to
3750
Flow BiĆdirectional Reverse acting Minimum Flow 5000
Important: Valve spanning procedures in chapter 9 require unselected
valves be driven at signal levels representative of a normal production run.
We discuss process considerations that impend changing these values in
chapter 10. Changing these values may require you to re-span your valves.
Enter all set-output values for unselected valves in worksheets 7-A – 7-L.