Rockwell Automation 1771-QDC, D17716.5.86(Passport) PLASTIC MOLDING MODULE - Manual (Page 227)

Tune Your Machine
Chapter 10
10-19
Figure 10.1
Example Injection, Pack, and Hold Profiles with Accl/Decel Ramps
Time
Hold Profile
Selected Valve
Decel Ramps
Pack Profile Selected
Valve Accel & Decel.
Ramps
Injection Profile
Selected Valve
Accel. Ramps
Hold
Profile
Pack
Profile
Injection
Profile
Pressure Velocity
Position
Important: When enabled, the QDC module applies ramp rates at the
beginning of each profile segment.
With caution, you can use ramp rates to smooth out jerky motion present
during large increases or decreases in pressure or flow.
If your application requires the use of ramp rates:
Never apply ramp rates until you have already tuned all applicable
pressure and velocity loops.
Ramp rates control selected and unselected valves. Therefore, even
though you may be controlling velocity, you can ramp ram (screw)
pressure during an injection profile prior to pack.
Ramp rates and ERC may not function properly together. Be very
careful if applying ERC and ramp rates on the same profile.
Using slow ramp rates may force pressure and velocity actuals out of
control because these actuals include the time spent ramping as well as
the time for each segment.
The QDC module uses ramp rates when beginning a profile or
movement, or when stepping from segment to segment within a profile.