Sensaphone 2800 - Manual (Page 94)

Sensaphone 2800 Manual
92
CHAPTER 6: CONTROLLING THE OUTPUT
The 2800 includes a relay output that can be used to control a light,
siren, or other device. The output is a Form-C Normally Open/
Normally Closed mechanical relay and is rated for up to 120VAC
2A. A sample wiring diagram is shown below:
Figure 1: Relay output connected to alarm
The output can be programmed to operate in one of 7 automatic
modes or it can operate in manual mode (default). The 7
automatic
modes allow the output to automatically turn on and off based
on individual alarms or any alarm. In
manual mode the output is
controlled via keypad command or remotely via touch-tone phone
(See Chapter 7). A description of each mode is shown below:
AUTOMATIC MODES
Mode 1 : Output on when zone 1 goes into alarm. Off when alarm
is acknowledged.
Mode 2 : Output on when zone 2 goes into alarm. Off when alarm
is acknowledged.
Mode 3 : Output on when zone 3 goes into alarm. Off when alarm
is acknowledged.
Mode 4 : Output on when zone 4 goes into alarm. Off when alarm
is acknowledged.
Mode 5 : Output on when zone 5 goes into alarm. Off when alarm
is acknowledged.