Sensaphone 2800 User Manual
Page 151
Appendix A: Checking for Proper Operation
149
APPENDIX A: Checking Your Sensaphone 2800
for Proper Operation
We recommend that you test your Sensaphone 2800 weekly to be
sure it is functioning properly. This will ensure that when a problem
arises the 2800 will be ready to alert the appropriate personnel.
Sensaphone also recommends you keep a log of performed tests,
and has provided you with a Test Log template at the back of this
manual.
There are several tests that can be performed:
1. Call the unit and listen to the Status Report. This will test
the unit's ability to answer the phone and speak a message. It
will also verify that the inputs are reading properly, the alarm
conditions are OK, the electricity is on, the microphone is
functioning (optional), and that the battery is OK.
2. Create a test alarm on each input and allow the unit to contact
all programmed telephone numbers. This will make sure that the
2800 is programmed properly. It will also prepare personnel to
respond appropriately when they receive a call from the 2800.
Listed below are suggestions on how to trip test alarms:
• Temperature sensors: Heat or cool the sensor.
• Motion sensors: Have someone walk in front of the sensor.
• Door/window sensors: open the door/window.
• Water sensors: Apply a small amount of water beneath the
sensor or use a wet towel and touch it to the sensor probes.
• Humidity sensors: Raise the humidity around the sensor by
holding a cup of hot water beneath the sensor.
• NO/NC Contacts: Open or close the contact.
• Power sensor: Disconnect the power supply.
Allow the unit to contact all programmed telephone numbers. This
will make sure that the 2800 is programmed properly. It will also
prepare personnel to respond appropriately when they receive a call
from the 2800.