Sensaphone 2800 - Manual (Page 38)

Sensaphone 2800 Manual
36
The 2800 will say “Enter channel number”
3. Enter a value between 1-4
4. Press ENTER.
The 2800 will say “ok” after several seconds
WIRELESS ZONE/SENSOR CONFIGURATION
Sensaphone 2800 wireless sensors may be configured indi-
vidually or all at once. The 2800 can have up to 4 wireless
sensors. You can also have 1 repeater to help extend the
range of sensors that may be too far from the unit to wire-
lessly communicate. The 2800 will automatically add sen-
sors in order as Zone 5, 6, 7 & 8. Make sure your sensor(s)
have been powered up for at least a minute before starting
the configuration procedure. To add one sensor at a time,
power up the sensor, wait 1 minute then apply the key
sequence below. Repeat this procedure for each additional
sensor. To add multiple sensors, power up all of the sensors,
wait 1 minute, then enter the key sequence below.
NOTE: This procedure is the same one used to con-
figure your hard-wired sensors. Make sure there are
no alarms on zones 1-4 when performing wireless
sensor configuration.
To add one or more wireless sensors:
1. Press the SET key.
2. Press the CONFIGURE key.