Sensaphone 2800 - Manual (Page 74)

Sensaphone 2800 Manual
72
• The 2800 can be instructed to wait for the call to be
answered before dialing additional digits. This is useful if
you need to call a company’s main number and then dial
additional digits to go to a specific extension (Example:
888-555-1200—wait for answer—227). Note that the unit
will automatically wait for answer after dialing the last
programmed digit. Press CODE 2 to make the unit wait for
an answer, as in the example.
Change to Touch-Tone Dialing
In a situation where you must use pulse dialing, pressing CODE 3
will change all following digits to Touch-Tone.
Special Dialing Code Summary
Special Dialing Codes for the 2800 are:
Code 1: Numeric pager type
Code 2: Wait for answer
Code 3: Change to Touch-Tone
DIAL-OUT TEST MODE
The 2800 allows you to test your telephone programming by
simulating an alarm dialout to any programmed telephone number.
This can be a valuable tool for insuring that your programming
is correct and also for troubleshooting dialing problems. In this
mode all signals on the telephone line are audible through the local
speaker.
To test a dialout phone number:
1. Press the SET key.