Sensaphone 2800 - Manual (Page 134)

Sensaphone 2800 Manual
132
MOUNTING
1. Remove front cover from sensor by placing a flathead screwdriver
in slot located on side of sensor, then rotate the screwdriver.
Screwdriver Slot
Figure 1
Warning: Do not face sensor toward the sun with the cover off. This
will damage the sensor.
2. Carefully remove the board from the pegs before attempting to
screw the back plate to the wall.
Screw Mounting Holes
Figure 2
3. Mount the back cover to the wall, using the accompanying screws
and the two knock-out slots for them in the back cover.
The sensor must be mounted with the long dimension parallel to
the floor and ceiling, with the sensor’s window to the left, not up.
The detector can be mounted in either a surface wall mount position