Sensaphone 2800 User Manual

Page 85

Chapter 5: Communication Programming

CALL PROGRESS

The 2800 monitors call progress when it dials out for an alarm.
If 2800 encounters a busy signal or receives no answer after ten
rings, the unit hangs up, waits the programmed intercall time and
then dials the next phone number. When dialing some beeper/pager
services, the line may be answered before receiving a ringback.
This may interfere with the call progress detection and result in a
failed call to certain phone systems or beeper/pager services. If this
occurs, disable call progress detection. Default setting is Enabled.

To enable/disable call progress detection:

1. Press the SENSOR ON/OFF key.

2. Press the STATUS/CONFIG key.

The 2800 will respond “Call Progress Enabled/Disabled” to indicate
that call progress has been turned on or off respectively.

3. Repeat key sequence to change back to previous settings.

VOICE REPETITIONS

The voice repetitions is the number of times the 2800 will recite
the alarm message per phone call when it dials out. This can
be programmed from 1 to 10 repetitions. The default value is 3
repetitions.

To program the voice repetitions:

1. Press the SET key