Sensaphone 2800 - Manual (Page 138)

Sensaphone 2800 Manual
136
WSR-0106 WIRELESS SPOT WATER DETECTION SENSOR
INTRODUCTION
The WSR-0106 Wireless
Spot Water Detection
Sensor is designed to
work with the Sensaphone
2800 Environmental
Monitoring System. This
sensor includes a built-
in radio transmitter and
water sensing probes for monitoring for the presence of water at a
particular location. The sensor comes with 3 AA alkaline batteries
which will power the sensor for up to 3 years.
NOTE: Do not install the entire sensor housing in a dirty,
humid, or corrosive environment. Do not install the sensor in
close proximity to other 2.4GHz devices (WiFi etc).
Package Contents
(1) WSR-0106 Wireless Spot Water Detection Sensor
(3) AA Alkaline batteries
CHANNEL SELECTION
The Sensaphone 2800 and associated sensors must be set to operate
on the same wireless channel. There are four possible channels. If
you will be installing more than one 2800 unit in the same area you
must configure each system on its own channel. By default the
2800 and sensors are set to channel one. To change the channel on
the sensor, remove the cover by removing the four outer screws on
the bottom of the enclosure. See Figure 1: