Sensaphone 2800 User Manual

Page 70

Sensaphone 2800 Manual

the automatic answer detection and timing from the 2800 is
incompatible with the paging service, and the Manual mode must be
used.

NOTE: If your phone system requires you to dial a

‘9’ followed by a pause to get an outside line, you
must use

Manual mode and insert pauses at the end

of the number.

When the 2800 calls your Numeric Pager it will leave the
programmed ID Number along with the Zone number that is in
alarm. If it’s reporting a Power alarm, it will send the ID Number
followed by the number “0”; if it’s reporting a Sound alarm, the
2800 will send the ID Number followed by the number “9”. To
acknowledge the alarm you will have to call the unit back and enter
an acknowledgement code, otherwise the unit will continue dialing
the remaining numbers.

To program a NUMERIC PAGER using AUTOMATIC Mode:

1. Press the SET key

2. Press the PHONE NUMBER key. 2800 will say “Enter Number.”

3. Select which Phone number to program. Press any unassigned

number key (keys 1–8) to represent the new telephone number
entry. 2800 will respond “Enter number.”

4. Press CODE 1 (This tells 2800 this is a Numeric Pager call).

The 2800 will say “Pager.”