Mounting, Electrical box installation, Surface installation – Sensaphone 2800 User Manual
Page 114
Sensaphone 2800 Manual
112
MOUNTING
The dry contact sensor can be mounted directly on a flat surface or
attached to a plastic single-gang electrical outlet box. Consideration
should be given as to whether or not an electrical outlet will be
required if using the optional power supply. Mount the sensor as
high as possible to provide for optimal wireless transmission. When
installed within a building where the wireless signal must travel
through several obstructions, the sensor should be located within
100’ of the Sensaphone 2800 or within 100’ of a repeater. If the
sensor has line-of-sight with the Sensaphone 2800 (or a repeater),
then it may be located up to 300’ away.
Electrical box installation
Using the hex key remove the sensor cover by turning the two hex
screws located on the bottom of the sensor housing clockwise.
Carefully lift off the cover. Attach the sensor housing to the
electrical box using the appropriate screws.
Surface installation
Remove the sensor cover by turning the two hex screws on the
bottom of the sensor housing clockwise. Use a pencil to mark the
hole locations at the top and bottom of the housing. Remove the
sensor from the wall. Install the drywall anchors (if necessary) to
the wall. Attach the sensor housing to the wall using #6 tapping
screws.
+
+
+
-
-
-
A1
A0
Mounting
Screws