Battery installation, Battery information, Installation – Sensaphone 2800 User Manual
Page 144
Sensaphone 2800 Manual
142
A0
0
1
A1
0
1
CH1
A0
0
1
A1
0
1
CH3
A0
0
1
A1
0
1
CH2
A0
0
1
A1
0
1
CH4
Figure 3
BATTERY INSTALLATION
After you have configured the channel, install the AA alkaline
batteries (as shown in Figure 2), replace the cover and secure it by
replacing the four screws on the bottom of the enclosure.
BATTERY INFORMATION
The projected battery life is dependent upon many factors including:
rated capacity of battery, state of charge, temperature, and sensor
distance from the 2800 (or repeater). The farther a sensor is from its
receiver the more power it will require to transmit its signal, thus
reducing battery life. Higher temperatures will also decrease battery
life. Always use high quality alkaline batteries in Sensaphone 2800
series wireless sensors. Remove the batteries from the sensor if you
will be taking it out of service for a period of time.
NOTE: If the sensor has only batteries installed and it is not
configured for communication with the 2800, it will consume
maximum power trying to establish communication and result in
premature battery failure.
INSTALLATION
Mount the enclosure on a wall close to the area to be monitored.
Connect the WaterRope to the connection on the side of the
enclosure. Secure WaterRope to floor with self adhesive clamps.