Sensaphone 2800 - Manual (Page 103)

Chapter 7: Operation
101
“Zone two, ‘Temperature in refrigerator two,’ 40 degrees
Fahrenheit, OK
“Zone three, ‘Water pressure monitor,’ OK
“Zone four, ‘Nitrogen gas tank level in percent,’ 15, too low,
acknowledged alarm exists
Wireless sensor five, ‘room humidity’, 45, OK
Wireless sensor six, ‘water detector’, OK
Wireless sensor seven, ‘motion detector’, OK
Wireless sensor eight, ‘ups alarm’, OK
“The Sound is OK”
“The Power is ON”
“The Battery is OK”
“The Output is off ”
“Listen to the sound for 10 seconds”
“Good-Bye”
REMOTE COMMANDS VIA TOUCH-TONE PHONE
You can issue a number of commands to the 2800 remotely using
a Touch-Tone telephone. This command mode can be entered at
any time during the status report. Simply press a Touch-Tone and
the unit will halt the report and respond with “OK.” You are now in
Touch-Tone command mode. Commands are available to perform
the following functions:
• Enable and disable zones, power monitoring, and sound
monitoring
• Recite/Set High and Low alarm limits
• Recite/Set telephone numbers
• Record/Play custom voice messages
• Recite/Set the relay output
• Activate the microphone for listen-in
• Recite status report
• Recite alarm history