Sensaphone 2800 - Manual (Page 43)

Chapter 4: Zone Programming
41
3. Press the corresponding Zone key (1–4).
The 2800 will say “Enter Mode.”
4. Press the key which corresponds to the type of Zone according
to the table below:
1: NO Dry Contact
2: NC Dry Contact
3: 2.8K Thermistor (temperature sensor)
4: 10K Thermistor (temperature sensor)
5: 4–20mA
5. Press ENTER.
The 2800 will recite the programmed Zone input configuration.
ENABLE/DISABLE ZONE ALARMS
This function allows you to enable or disable a Zone (1-8) for
dialout during an alarm. An enabled Zone will respond to an alarm
and allow dialout. A disabled Zone will not initiate a dialout, but
it will still be included in the status report, preceded by the word
“disabled.” This command is useful while you are wiring your
Zones or at any other time you would like the alarms to be ignored.
The default setting for all Zones is enabled (on).
To enable/disable Zones:
1. Press the SENSOR ON/OFF key.