MacDon CA25 OM - Manual (Page 93)

SECTION 7. OPERATION
169593
91
Revision B
7.15.3.2 Rear Wheels To Field Position
a. Pull pin (A) at left wheel, swivel wheel
clockwise, and lock with pin (A).
b. Remove pin at (B). Store pin at (C) as shown.
c. Pull handle (D) to release.
d. Lift wheel to desired height, and engage
support channel into slot (E) in upper support.
e. Push down on handle (D) to lock.
f. At right cutterbar wheel, pull pin (F) on brace
(G), disengage brace from cutterbar, and lower
the brace against axle (H).
g. Remove pin (J), lower the support (K) onto axle,
and re-insert pin into support.
h. Swing axle clockwise to rear of header.
i. Pull pin (L) at right wheel, swivel wheel
counterclockwise to position shown, and lock
with pin.
j. Remove hairpin (M) from latch (N).
k. Lift wheel, lift latch (N), and engage lug (O) onto
left axle. Ensure latch closes.
l. Secure latch with hairpin (M).
(continued next page)
TRANSPORT TO FIELD - RH SIDE
G
F
Release
Lock
M
N
O
L
TRANSPORT TO FIELD - LH WHEEL
A
TRANSPORT TO FIELD - LH WHEEL
C
D
E
B
RELEASE
LOCK
TRANSPORT TO FIELD - RH WHEEL
K
J
H
G
F