MacDon CA25 OM - Manual (Page 39)

SECTION 7. OPERATION - JOHN DEERE 60, 70, and S SERIES
169593
37
Revision B
7.3.3.2 Detachment
a. Choose a level area. Position header slightly
above ground. Stop engine, and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift
cylinder stops before going under header
for any reason. See your Combine
Operator’s Manual for instructions for use
and storage of header lift cylinder stops.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Engage both adapter float locks by lifting lever
(A) at each lock until it latches into the lock
position.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached
in either Transport or Field mode.
If detaching with wheel in Field
mode, set wheels to storage or
uppermost working position.
Otherwise header may tilt forward
so that re-attachment will be difficult.
Refer to Section 7.9.1 Cutting
Height.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or uppermost
working position. Otherwise header
may tilt forward so that
re-attachment will be difficult. Refer
to Section 7.9.1 Cutting Height.
c. Open shield (B) on combine. Pull back collar
on driveline, and pull driveline (C) off combine
output shaft.
d. Slide driveline in hook (D) so that disc (E) drops
to secure driveline.
e. Lift handle (F) on adapter.
(continued next page)
F
B
C
A
LOCK
UNLOCK
E
D