MacDon CA25 OM - Manual (Page 180)

SECTION 8. MAINTENANCE AND SERVICING
169593
178
Revision B
8.12.9.3 Removal: Plastic Fingers
a. Remove screw (A) with a Torx
®
-Plus 27 IP
socket wrench.
b. Push finger top clip back toward reel tube, and
remove from finger tube.
8.12.9.4 Installation: Plastic Fingers
a. Position finger on rear of finger tube, and
engage lug at bottom of finger in lower hole in
finger tube.
b. Gently lift top flange, and rotate finger until lug
in top flange engages upper hole in finger tube.
IMPORTANT
Do NOT apply force to finger prior to
tightening mounting screw.
Applying force to finger without
screw tightened will break finger or
shear off locating pins.
c. Install screw (A), and torque to 75–80 in·lbf
(8.5–9.0 N·m) with a Torx
®
-Plus 27 IP socket
wrench.
REMOVAL
INSTALLATION
A
A