MacDon CA25 OM - Manual (Page 170)

SECTION 8. MAINTENANCE AND SERVICING
169593
168
Revision B
g. Remove U-joint.
NOTE
Right hand reel may need to be
moved sideways for U-joint to clear
reel tube.
h. Position U-joint flange (H) onto driven sprocket
(J) as shown. Install six bolts (G), and
hand-tighten. Do not torque at this time.
i. Position RH reel tube against reel drive, and
engage stub shaft into U-joint pilot hole.
j. Rotate reel until holes in end of reel tube and
U-joint flange (F) line up.
k. Install four bolts (C), and torque to 70–80 ft·lbf
(95–108 N·m).
l. Torque bolts (E) to 70–80 ft·lbf (95–108 N·m).
m. Remove temporary reel support.
n. Re-attach reel drive covers.