MacDon CA25 OM - Manual (Page 61)

SECTION 7. OPERATION
169593
59
Revision B
7.5 BREAK-IN PERIOD
a. After attaching header to combine for the first
time, operate the machine with reel drapers and
sickle running slowly for 5 minutes, watching
and listening FROM THE OPERATOR'S SEAT
for binding or interfering parts.
NOTE
Reel and side drapers will not operate
until oil flow fills the lines.
CAUTION
Before investigating an unusual sound or
attempting to correct a problem, shut off
engine, and remove key.
NOTE
Until you become familiar with the
sound and feel of your new header, be
extra alert and attentive.
b. Perform the items specified in to Section 8.4.2
Break-In Inspections.
7.6 SHUTDOWN PROCEDURE
CAUTION
Before leaving the combine seat for any
reason:
 Park on level ground if possible.
 Lower the header fully.
 Place all controls in NEUTRAL or PARK.
 Disengage header drive.
 Stop engine, and remove key from
ignition.
 Wait for all movement to stop.
7.7 HEADER CONTROLS
CAUTION
Be sure all bystanders are clear of
machine before starting engine or
engaging any header drives.
See your Combine Operator's Manual for
identification of in-cab controls for:
 Header
Drive Clutch
 Header
Height
 Header
Angle
 Ground
Speed
 Reel
Speed
 Reel
Height
 Reel Fore-Aft Position