MacDon CA25 OM - Manual (Page 38)

SECTION 7. OPERATION - JOHN DEERE 60, 70, and S SERIES
169593
36
Revision B
2. Locate coupler (G) onto receptacle, and
pull handle (A) so that lugs on coupler are
engaged into handle.
3. Pull handle to full horizontal position as
shown.
4. Slide latch (H) to lock handle in position,
and secure with lynch pin (J).
5. If adapter is equipped with reel
fore-aft / header tilt selector, connect
harness (K) to combine connector (L).
l. Rotate disc (M) on adapter driveline storage
hook, and remove driveline from hook.
m. Pull back collar (N) on end of driveline, and
push onto combine output shaft (O) until collar
locks.
n. Disengage both adapter float locks by moving
latch (P) away from adapter, and moving lever
(Q) at each lock to lowest position.
J
H
A
G
K
L
O
N
P
LOCK
UNLOCK
Q
M